GreenPAK and GreenFET
4 months agoPosted by Ricardo 55 points 6 replies
I'm new to GreenPAK and I'm trying to use the SLG46880 ASM, but I can't seem to get even a very simple ASM to change state in the simulator.
I've looked at all of the example app notes and pre-built projects (.gp6) but I can't see any that actually using the newer ASM type used in the SLG46880.
As a test project, I have just three states (S0 Start, S1 Run, S2 End) with two GPI inputs (GP0 and GP1). I've set up the state transitions such that GP0 should transition from S0 to S1 and GP1 should transition from S1 to S2. I apply a pulse to GP0 and then after a delay a pulse to GP1.
I can't see a way to directly monitor the ASM state in the simulator so I'm using the ASM OUTPUT0 macrocell to do the monitoring. When I simulate, OUTPUT0 shows I'm in S0 and it just stays there.
What am I doing wrong?
.gp6 file is attached, renamed as a txt.
|Rename to Basic.gp6||121.99 KB|