To order a sample of any of our products, please complete the following form. We will provide up to five parts free of charge. Our sales department will provide pricing for samples orders exceeding five parts.
AC/DC Secondary-Side Controller for Qualcomm® Quick Charge™ 3.0 USB Interface
The iW636 is a Rapid Charge™ secondary-side controller for USB interface supporting Qualcomm Quick Charge 3.0 technology and secondary-to-primary communication protocol, that works with the iW1782 or iW1780H primary-side AC/DC digital controller with to enable rapid charging of QC3.0/QC2.0-enabled mobile devices (MDs).
The iW636 integrates an opto-coupler driver that relays commands to the iW1782 or iW1780H AC/DC controllers. These chipsets provide efficiency as high as 90% to enable the higher power density needed for small form-factor fast charging adapters. It also uses Dialog's SmartDefender™ smart hiccup technology to help address soft shorts in cables and connectors.
Qualcomm® Quick Charge™ is a product of Qualcomm Technologies, Inc.
Supports Qualcomm® Quick ChargeTM 3.0 technology High Voltage Dedicated Charging Port (HVDCP) to provide VBUS from 3.6V to 12V in 200mV increments
Double-layer cable protection:
- Secondary side (iW636): Proprietary D+/D- overvoltage protection (OVP) addresses VBUS D+/Dsoft shorts
- Primary side (iW1782 or iW1780H): SmartDefender™ smart hiccup technology reduces average output power at fault conditions without latch
Proprietary secondary-to-primary digital communication eliminates discrete decoders in the primary side and simplifies system designs
Single opto-coupler transmits all information for rapid charge: output voltage requests, output current limits, output voltage undershoot (UV), over-voltage protection (OVP), and fault and reset signals
Adaptive OVP/UV detection for most VBUS levels
Backward compatible with QC2.0 and USB Battery Charging Specification Revision 1.2 (USB BC1.2)
Pin-to-pin compatible with iW626
Programmable active fast discharge from a high voltage VBUS level to 5V at mobile device unplug or upon request with built-in switch or external switch
Normally OFF state with <150 µA cut-off current during 5V steady-state operation to achieve <10mW overall system no-load power consumption
Wide operating voltage range from 3V to 16V
Built-in opto-coupler LED driver with minimum driving current of 2mA
Rapid-charging AC/DC adapters for smart phones, tablets, and other portable devices